VW Touran EDC16U31/34 DPF EGR Remove by DPF EGR Lambda Remover

Here is a operation guide on how to use DPF EGR Lambda Remover to remove the DPF and EGR for VW Touran EDC16U31 and EDC16U34.

 

DPF EGR Lambda Remover Software Download & Installation & Activation

 

Procedures to Remove EGR:

Before you start using DPF EGR Lambda Remover,you need to use ECU read/write programmer (FGTECH Galletto, KESS V2, KTAG Master, MPPS) to read out ECU file.

Then run EGR remover

Select “Volkswagen” from the Car Model section

Select “EDC16U34 Generic”

Then select the ECU bin file read by ECU programmer

 

Now it will prompt you with massage;

“EGR Map(s) Found

Do you want remove EGR”

Click “OK” to continue

Now you need to save the new ECU bin file(no EGR)

It prompt you:

DTCs has been deleted

EGR Map1 has been disabled

EGR Map2 has been disabled

Successfully Removed!!

PLEASE DON’T FORGET FIXED THE CHECKSUM!

 

Procedures to Remove DPF:

This operation like EGR removing operations.

Run the DPF Remover

Select “Volkswagen” from the Car Model section

Select “EDC16U34 Generic Switch”

Then select the ECU bin file you saved (the file EGR removed)

DPF Map(s) Found

Do you want to remove DPF?

Click “OK” to continue

Save the new ECU file with a new name(no_EGR_no_DPF)

EDC16U34 Generic Switch Detected OK.

DTCs has been deleted

Map or Switch Point 1 has been disbled

Successfully Removed!!

Finally,you need to use ECU programmer to write the ECU bin file you saved just now back to ECU.