Volvo PTT Do Cruise Control Parameter Programming for Mack I II III

This article show a guide on how to use Volvo PTT to do parameter programming for Mack I II III.And if you want to get more project about Volvo projects,please check here:Volvo PTT Test Cases.

 

What You Need?

2024 Volvo  TechTool PTT 2.8.241 APCI 0.7.1.0/2.7.116 All Version Free Download

Volvo Diagnostic Kit (88890300)

Volvo VOCOM 88890300 Diagnostic Kit

 

 

Procedures:

Connect Volvo PTT interface to vehicle and run Volvo PTT software and login in with your user ID and password.

Select “Manual Selection”

Select “Mack Trucks”,”V-MAC…”,”MACK” in the company section,then click “OK” to continue

Enter a work order number or select a recently used work order number in the list,here enter a work order number “test 2” and click “Start Work” to continue

Then select “Program”

If it prompt you with “Security Warming ” massage,please check the box “I accept the risk and want to run this ….” then click “Run” to continue

When Volvo PTT finish preparation checking,you will get below window

Select “Service and maintaining”–>”Parameter Programming”,then click “Start” button to process.

Warming massage,click “Start” to continue

Then click the “Start” button on the toolbar

If it will prompt you that the parking brake must be applied,check it and continue.

Now Volvo PTT will reading data from the control unit

Now you can click control unit to view the parameter values

Select value you want to change,and input a new value.

Here change “Cruse Max Vehicle Speed” of Cruise Control unit,from 65 to 63

Click “Continue”

And then click “Program”

Finally,you need to input vehicle ECU password to continue parameters programming.

Done!