This instruction show you Launch X431 programming Porsche Panamera level system after air spring replacement. More post about Porsche repair,please check here:Porsche trouble repair.
Caution:
Ensure the supply voltage is not under 12V during the operation.
Other operations should meet the requirements prompted.
Operation Guideline:
1.Select Porsche Version V21.80 or above.
2.Select automatic search
3.Select rapid test, click YES.
4.Select Level Control
5.Select version information.
6.After confirming the Porsche part number and diagnostic software number, click OK
7.Select special function.
8.Select replacement of air spring
9.Click [Charge an air spring]
10.Click OK, enter the interface and view the status and value of the battery voltage,ignition and engine speed
11.Click Next, select the second item of air spring selection, it appears 4 options of front left, front right, rear left and rear right
12.Select air spring selection
13.For example, select the second item [Front right], click [Start], the value of “Inflate air springs using pressure accumulator” and “Conclude filling process” changed from “wait” to “function completed”, and the status is OK
14.After the front right item, click [air spring selection] to select any one of front left, rear left and rear right. Click [Start]
15.To bleed the air spring, click [air spring ventilation] in the special function
16.Click OK, enter the interface and view the status and value of the battery voltage, ignition and engine speed
17.Click Next, select the second item of air spring selection, it appears 4 options of front left, front right, rear left and rear right
18.Select [Front right].
19.Click [Start], pay attention to the prompt, the value of “bleed air spring” changed to function completed and the status is OK
20.After the front right item, click [air spring selection] to select any one of front left, rear left and rear right. Click [Start], repeat the above two steps
More Launch X431 Training article,please check here:Launch X431 use guide
This instruction show you guide on how to bleed air from the fuel system for…
This instruction show you guide on how to solve Doosan and Bobcat Electric problems can…
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…