In this post,car-auto-repair.com show you guide on how to use MUT-III diagnostic software to do ECM reprogramming for Mitsubishi Lancer 2008. More post for Mitsubishi,please refer to Mitsubishi Trouble Repair
Preparations:
2020 MUT-3 MUT-III Mitsubishi Diagnostic Software Free Download
MUT-III ECU Rewrite ROM Data from 2009 to 2021
MUT-III Diagnostic interface (Openport 2.0 adapter Amazon Shop)
Procedures:
Connect Openport 2.0 adapter to Mitsubishi Lancer obd port
Then run MUT-III software,select “STV”
Click “ECU programming” button
Click “ECU Reprogramming”
Select “ETACS”,”Can’t see P/N on ECU”
Select data from right side,then click “OK” button to start reprogramming
Now it is performing programming process,just wait
Completed
On-board ECU has been reprogrammed
To finish reprogramming,turn OFF IG switch
Press the OK button to confirm the result of reprogramming
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…