Mack and Volvo EPA13 GHG17 Engine NOx Conversion Monitor Test

This instruction show you guide on how to use JPRO TO perform Mack and Volvo EPA13 GHG17 engine NOx Conversion Monitor Test.

 

Related Contents:

2024 JPRO Noregon Commercial Fleet Diagnostics Free Download

Noregon JPRO DLA+ 2.0 Adapter

 

The NOx Conversion Monitor Test is supported on:

✓ Mack and Volvo EPA 13 to GHG17 engines

The NOx Conversion Monitor Test checks the SCR system’s efficiency in reducing NOx in the exhaust gas. The test  can be used for confirmation of active DTCs, DEF quality check, and comparing system behavior before and after repair.

 

Procedures:

1 Select the NOx Conversion Monitor Test and press Enter or select the Start button.

2 The NOx Conversion Monitor Test dialog will be displayed.

3 Select the Additional Info button to view additional details concerning this test.

4 To begin the test, press the Start button. The lamp to the left of the Start button will change from “Not Running” to “Running” and highlight as well. The button will change to Stop.

5 A confirmation message box will display the first time the test executes. After reading this important information, select Ok.

6 As the test runs, the status area will show what is occurring and the current state. Once the test completes, the status area will display the test results.

7 To end test at any time, press the Stop button.

8 To leave this dialog, select the Exit button.

 

More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide