This instruction show guide on how to adjust neutral for Kubota L330 L3901 L4701 excavator.
Related Contents:
2024 Kubota Takeuchi Diagmaster v24.01.06 Software Free Download
Kubota EPC Spare Parts Catalogue 2021.06 Download
CAUTION
• Stop the engine when adjusting the HST neutral.
1. Set the cruise control lever to “OFF” position. (HST pedal is in Neutral position.)
2. Check to see that the length a of HST control rod (2) and the length b of neutral rod (6) are specified length.
If not, adjust as follows.
Length “a”: 231.2 to 232.2 mm (9.07 to 9.11 in.)
Length “b”: 138.5 to 139.5 mm (5.49 to 5.53 in.)
3.Loosen the hex. head screw (3) to make situation that HST control lever (4) moves freely. Operate the engine for 5 seconds to make sure that the HST is in neutral position.
4. Tighten the hex. head screw (3) so that the HST control lever (4) does not turn.
NOTE
• Be sure to tighten the hex. head screw with specified torque
More repair case for Kubota,please refer to:Kubota Trouble Repair
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…
This instruction show you guide on how to solve Caterpillar C9 engine 31 84-1 fault…
This instruction show you guide on how to charge and discharge accumulator for JCB 3CX,…