Several days ago,car-auto-repair.com share a guide on How to Repair JCB Equipment K0124 Boost Pressure High Trouble.Today here share another related guide on how to repair JCB K0125 boost pressure deviation is too high.More repair case for JCB,please refer to:JCB Trouble Repair
Related Content:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
2024 JCB ServiceMaster 4 v24.3.1 Free Download for Win 10 Win11
The measured boost pressure differs too much from the desired value.
Possible causes are:
The boost air piping is leaking.
The EGR pipe is leaking.
The turbocharger is defective.
The engine is mechanically defective.
The turbo waste gate is not moving easily.
The waste gate actuator is defective.
Reaction in EEM
The FC is stored and the warning lamp is activated. Engine power will be reduced (Degradation Level 1). The CAN message indicates active fault.
Solution
Find the cause for the low boost pressure indication:
Check the boost air system tightness (piping, intercooler).
Check the turbo waste gate flap and the condition of the actuator. The actuator should move in the ECU initialization.
Check the condition of the turbo charger.
Check the mechanical condition of the engine.
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…