The Aftertreatment Fuel Enable Actuator Leak Test is used to check the aftertreatment hydrocarbon doser for leaks.The test should be run twice. The first time is used to purge fuel from the doser supply line. The second time is used to confirm there are no leaks.
Related Contents:
2024 JPRO Noregon Commercial Fleet Diagnostics Free Download
The aftertreatment hydrocarbon doser must be removed before running this test to prevent vehicle damage.
1 Select Aftertreatment Injector Activation for Flow Test and press Enter or the Start button.
2 The test dialog will be displayed.
3 Once all instructions have been followed and preconditions have been met, select a Delay Start Time, if desired,and click the Start button to begin the test.
4 When the test has completed, Click the Exit button to return to the test selection dialog.
More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…
This instruction show you guide on how to solve Caterpillar C9 engine 31 84-1 fault…