How to Use Volvo Vocom I 88890300 Diagnostic Adapter

This instruction show you guide on how to use Volvo VOCOM I 88890300 to connect vehicle.

 

Related Conetents:

2024 Volvo  TechTool PTT 2.8.241 APCI 0.7.1.0/2.7.116 All Version Free Download

Volvo PROSIS 2023 2019 2018 Parts Catalog & Repair Manuals Free Download

Volvo Diagnostic Kit (88890300)

Volvo VOCOM 88890300 Diagnostic Kit

 

Connecting VOCOM I:

Get started by starting up the laptop and put vehicle ignition ON.

Check if correct cables are used. The different product classes use different interfaces and adapter cables to connect. The tables below show what interface and corresponding adapter cables to connect to different product classes.

Note: The tables may not be applicable to all markets.

 

Installing VOCOM I

This is how it should appear the first time you connect the communication unit to a computer.

The pictures in the installation instruction serves as illustrations, the actual dialogues and pop-ups may look different depending on which communication unit and Windows you are using.

A small window in the lower right corner will state Installing device driver software.

After a while, a small pop-up appears in the lower right corner and states that new hardware has been installed and is ready to use.

 

LEDs description

The communication unit has a number of different coloured LEDs. These LEDs show the status of the communication unit and indicate warnings, etc. Refer to the table below for an overview.

 

Note: All LEDs light up during startup of the communication unit. This is to check that all the LEDs function.

 

Communication unit monitor

Communication Unit Monitor is an application that checks if the software and driver of the communication unit matches.

When connecting a communication unit the Communication Unit Monitor checks if the software in the communication unit and the driver are compatible. If they are incompatible a message will be shown informing that the software has to be updated.