Caterpillar Electronic Technician service tool allow you to perform ECMs programming for new or used ECMs. All ECMs connected to the service tool will display in the ECM Information area.
Related Contents:
Caterpillar ET 2024A 2023C 2019C 2018A Electronic Technician Software Free Download
CAT Adapter 3 ET4 478-0235 High Quality Diagnostic Adapter
Caterpillar SIS 2021 2019 2018 Full EPC+Service Manual Free Download
Caterpillar Factory 18 Digits Password Service
Instructions
To program an ECM:
Click the Browse button. The File Selection dialog box is displayed.
Note: If the Search button is clicked, the location set in the CBT tab of the Preferences dialog box will be accessed.
Select the desired file and click Open. The WinFlash screen is displayed, and ECM/File information is populated with information from the flash file.
Click the Begin Flash button. If more than one ECM has been selected for flashing, the Flashing Order confirmation dialog box is displayed (see below). This allows users to determine the order in which the ECMs will be flashed.
Click OK to continue the flashing process.
The Flashing screen is displayed and the flash process will begin. This process may be canceled at any time for one ECM by clicking the Cancel button or for all ECMs by clicking the Cancel All button.
When the flash process completes, a dialog displays that allows a return to the CAT ET 2023A service tool, a return to WinFlash, or an exit from the service tool.
Note: If problems occur during programming, a status dialog box displays after programming is complete. This dialog box provides a list of the ECM(s) that could not be flashed as well as the cause of the error(s).
Possible Dialog Boxes
Successfully Completed – If all checked ECMs were successfully programmed, the “Flash Completed Successfully” dialog box is displayed.
Flash Error – If multiple ECMs are being programmed and one ECM does not program correctly while all other ECMs were successfully programmed, the “Flash Error” dialog box is displayed.
Aborted – If Cancel is clicked while the ECM is being programmed, the “Flash Aborted” dialog box is displayed:
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…
AGCO EEM Dosing module Description The dosing module (DM) is installed in the exhaust…