Heavy Equipment Repair

How to Solve Cat C9 Engine PID 102-3 Boost Pressure Voltage High?

Here is the instruction show you guide on how to solve Caterpillar C9 engine PID 102-3 boost pressure voltage high.

Related Contents:

Caterpillar ET 2025A 2024A 2018A Diagnostic Software Free Download

CAT Communication Adapter 3 478-0235

Caterpillar Factory 18 Digits Password Service

 

The Engine Control Module (ECM) detects the following conditions:

The signal voltage from the boost pressure sensor is greater than 4.95 VDC for more than two seconds.

The ECM has been powered for at least two seconds.

The engine is not running or the rack position is less than 50 percent with the engine retarder off.

 

The Engine Control Module (ECM continuously creates a pull-up voltage on the signal wire for each sensor. The ECM uses this pull-up voltage in order to detect a problem in the signal circuit.

 

When the ECM detects voltage that is above a threshold on the signal wire,the EM activates a-3 diagnostic code. when the ECM detects voltage that below at threshold on the signal wire,the ECM activatesa-4 diagnostic code.

 

Note:When you check for a diagnostic code, be sure to wait at least 30 seconds.

 

The most likely cause of a code is a problem with an electrical connector or wiring. The least likely cause of a code is the ECM.

The following sensors are included in this code:

Fuel pressure sensor

Injection actuation pressure sensor

Barometric pressure sensor

Boost pressure sensor

Engine oil pressure sensor

 

Probable Causes:

1)ECM Connection

2) Sensor failure

3)Sensor harness/connector

4) ECM Failure

 

More repair case for Caterpillar machine,please refer to:Caterpillar Machine Repair

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

6 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

2 weeks ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

2 months ago