How to Remove and Install Oil Filter Base for Perkins 800D Series Engine

This instruction show you guide on how to remove and install oil filter base for Perkins 800D series engine.

 

Related Contents:

Perkins EST 2024A & 2023A & 2019A Software Free Download

Perkins SPI2 2018A EPC+Service Manual Free Download

 

 

Removal Procedure

 

1 Use Tooling (A) to remove engine oil filter (6) from engine oil filter base (5). Refer to Operation

and Maintenance Manual, “Engine Oil and Filter- Change”.

2 Mark the orientation of engine oil filter base (5) for installation. Remove bolt (2).

Note: The engine oil filter base can be oriented in different positions.

3 Remove bolt (4) and remove engine oil filter base (5) from the cylinder block. Plug the oil galleries in the cylinder block with suitable plugs.

4 Remove O-ring seal (1) from engine oil filter base (5).

5 Remove O-ring seal (3) from bolt (4).

 

Installation Procedure

1 Ensure that the engine oil filter base is clean and free from damage. Clean the mating surfaces of the cylinder block.

2 Install a new O-ring seal (1) to engine oil filter base (5). Install a new O-ring seal (3) to bolt (4).

3 Position engine oil filter base (5) against the cylinder block. Install bolt (4) finger tight.

4 Ensure the correct orientation of engine oil filter base (5). Install bolt (2) finger tight.

Note: The engine oil filter base can be oriented in different positions.

 

5 Tighten bolt (4) to a torque of 50 N·m (37 lb ft).

Tighten bolt (2) to a torque of 11 N·m (97 lb in).

6 Install a new engine oil filter (6). Refer to Operation and Maintenance Manual, “Engine Oil and Filter – Change” for the correct procedure.

More trouble repair case for Perkins,pls refer to:Perkins Trouble Repair