In some cases you need to remove BMW Light Control Module and then re-install it,such as: repair bmw light control module or replace a new one.So I share this easy guide on BMW Light Control Module Removal Guide.And I put the video guide at the end of article,if you want to get detail information about it,pls watch the video!Hope it is helpful!
Step 1:Pry up the light control module cover carefully by slotted screwdriver (show in picture),then remove the cover.Turn the rotary knobs around the light control module into horizontal position.
Step 2:Unscrew the bolts by phillips screwdriver,and pry up the light control module in order to make it easy to pull up.
Step 3:Press the button and pull down the white snap joint,then disconnect the wire connector.
Done! You have removed the Light Control Module successfully.
Installation is the reverse of removal.
Video guide on how to remove and install BMW Light Control Module.
This instruction show guide on how to solve JCB JS140/205/215 machine trouble code P2280-00 air…
This instruction show you guide on how to do deactivation test for MANITOU MT6034 telehandlers…
This instruction show you guide on how to solve Liebherr machine ECU2 P1119-00 trouble code…
This instruction show you guide on how to solve Bobcat machine trouble code P18A5 suction…
The measured intake manifold pressure (signal from boost pressure sensor) is below the warning limit…
JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…