How to Jump-start Engine for MANITOU MT6034 Construction Telehandler

If the battery becomes discharged or does not have enough power to start the engine, use jumper cables and the following procedure to jump-start the engine.Here is the instruction show you guide on how to perform jump-start engine for MANITOU MT6034 construction telehandler.

IMPORTANT: BE SURE that the jumper battery is also a 12-volt D. C. battery, and the vehicle

used for jump starting has a negative-ground electrical system.

 

Related Content:

2026 Manitou I.V Interactive View Diagnostic Kit Software

 

Procedures:

1 Turn the key switches on both units to OFF. Be sure that both units are in “Neutral” and NOT

touching.

 

2 Connect one end of the (red) positive (+) jumper cable to the positive (+) battery terminal on the disabled machine first. DO NOT allow the positive (+) jumper cable clamps to touch any metal other than the positive (+) battery terminals. Connect the other end of the positive (+) jumper cable to the jumper battery positive (+) terminal.

 

3 Connect one end of the (black) negative (-) jumper cable to the jumper battery negative (-) terminal.

4 Make the final negative (-) jumper cable connection to the disabled machine’s engine block or

frame (ground) ⎯ NOT to the disabled machine negative battery post. If making the connection to the engine, keep the jumper cable clamp away from the battery, fuel lines, and moving parts.

NOTE: Twist the jumper cable clamps on the battery terminals to ensure a good electrical connection.

 

5 Start the engine. If it does not start immediately,start the jumper vehicles engine to avoid excessive drain on the booster battery.

 

6 After the machine has started and is running smoothly, have the second person remove the

jumper cables (negative (-) jumper cable first) from the jumper vehicle battery, and then from the

disabled machine, while being careful not to short the two cables together.

Allow sufficient time for the alternator to build up a charge in the battery before operating the machine or shutting off the engine.

 

NOTE: If the battery frequently becomes discharged, have the battery checked for possible

dead cells, or troubleshoot the electrical system for possible short circuits or damaged wire insulation.