This post will how you guide on how to do mileage correction with OBDPROG m500 doctor for 2010 Ford Kuga. For more cases about Ford, please visit here: FORD.
Procedure:
Connect OBDPROG to vehicle OBD port, than running it.
Select “FORD LINCOLN”
Click “Enter” for FORD/LINCOLN V30.88”, then select “FORD”>>”KUGA”>>”2010”
Click “Enter” for Mileage Calibration”
Current mileage: 69888KM.
Please confirm the milage correctly and press ENTER to continue.
Mileage is read and written in KM. Check the dashboard reading.
Click “Enter” then input “112650”
Reading is update on dashboard.
Calibration function complete.
If you are interested in mileage cases, welcome to click this post :Europe Ford Focus Mileage Programming after Replacement by Launch X431
This instruction show you guide on how to solve spool brake solenoid open circuit for…
This instruction show you guide on how to remove and install crankshaft rear seal for…
This instruction show you guide on how to use JPRO diagnostic to do SCR performance…
Here is the instruction show you guide on how to remove and disassemble master cylinder…
This instruction show you guide on how to solve Deutz EMR engine 71 / 2791 /…
Here is the instruction show you guide on how to repair P0731 incorrect 2nd gear ration…