Categories: Excavator Repair

How to Calibrate Speed Control Components for Bobcat M-Series Excavator

Bobcat M-Series Excavator engine speed control components must be calibrated any time the controller (Item 1) and or the actuator (Item 1) has been replaced or if the linkage (Item 2) has been adjusted.More repair topic for Bobcat,please refer to:Bobcat Excavator Repair

With the engine off, turn the key (Item 1) to the on position. Rotate the engine speed control dial (Item 2) to the high speed position.

 

Connect the linkage (Item 1) to the actuator.

Loosen the nuts (Item 1) and turn the threaded rod (Item2) until the lever (Item 3) fully contacts the stop (Item 4).Tighten the nuts (Item 1).Leave the engine speed control dial at the high speed position and turn the key to the stop position.The following procedure must be completed within 7.5seconds;With the engine off and the engine speed control dial at the high speed position, turn the key to the ON position.

Turn the engine speed control dial (Item 1) from the high speed position to the low speed position four times:

High Speed

Low Speed

High Speed

Low Speed

High Speed

Low Speed

High Speed

Low Speed

NOTE: The auto idle icon (Item 2) will flash while the calibration procedure is in process.When the calibration procedure is complete, the operator warning alarm will sound twice. Turn the key to the stop position.

NOTE: The actuator rod (Item 1), linkage (Item 2) and lever (Item 3) will move several times during the calibration procedure. Keep all personnel, tools and shop towels away from all moving components while performing the calibration procedure

auto

Recent Posts

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

7 days ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

2 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

3 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

4 weeks ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago

How to Solve Caterpillar C9 Vehicle Speed Signal Invalid?

This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…

1 month ago