Categories: Excavator Repair

How to Adjust Throttle Lever for Takeuchi TB128 Excavator

This instruction show you guide on how to adjust the throttle lever for Takeuchi TB128 mini excavator.More information about Takeuchi excavator workshop manual please refer to:Takeuchi Excavator Workshop EPC+Service Manual 2018 PDF Files

 

Adjust Throttle Lever for Takeuchi TB128 Excavator

Engine revolution:

1.Fasten the wire (2) to the throttle lever (1) with the wire lock pin (3).

2.Move the throttle lever (1) to the “A” (low idle) position and the governor (4) to the “C” position (idle).

  • Make sure that the throttle lever (1) hits against the stopper (5).

3.Fasten the wire (2) with the wire lock pin (6).

4.Move the throttle lever (1) to the “B” (full throttle) side and set the governor (4) to the “D” (full throttle) position.

  • Adjust the stopper (7) so that the throttle lever (1)hits against the stopper (7), and secure the stopper with the lock nut (8)

 

Control force

1.Loosen the lock nut (9) and turn the nut (10) to adjust the control force.

Control force 29.4 N

“2. Service data, Performance criteria, Lever operating force”

2.Upon completion of the adjustment, tighten the lock nut (9) by holding the nut (10) to prevent it from turning.

3.Operate the throttle lever (1) again to make sure that the control force is stable.

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

3 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

1 week ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago