This article show Lexus immobilizer key programming by carprog.
Support Lexus Models & Years
| Lexus Models | Year | Transponder Key Type |
| ES330 | 1998-2001 2002-2004 | TEX TEX |
| ES330 | 2004- | TEX/CR |
| GS300 | 1998- | TEX |
| GS300 | 1998-2000 | TEX |
| GS400 | 2001- | TEX |
| GX470 | 2004- | TEX/CR |
| IS200 | 2000-2004 | TEX |
| IS300 | 2000-2004 | TEX |
| LS200 | 1997-1999 1999- | TEX TEX |
| LS400 | 1997-1999 | TEX |
| LX450 | 1997-1999 1999- | TEX TEX |
| LX470 | 1999- 1999-2004 2004- | TEX TEX TEX |
| RX300 | 1999- | TEX/CR |
| RX330 | 1999- | TEX |
| SC300 | 1997-1999 1999- | TEX TEX |
| SC400 | 1997-1999 | TEX |
| SC430 | 2004- | TEX/CR |
Carprog Related Contents:
Carprog Software Free Download
Carprog Software Installation Guide
Older Lexus immobiliser system with separated immo box and Texas transponder (4D by Silca). Immobiliser box are located near to ignition key. Usually this is black or brown box marked “immobilizer” or “134.2 kHz”.
Remove immobiliser ECU from the car and open it. Find 93C66 EEPROM in DIP package. Use A5 or A4 adapter and follow CarProg instruction to program transponder key. Short quartz resonator for in-circuit EEPROM programming or remove 93C66 from immobiliser board.
Lexus immobiliser system with transponder antenna and AMP unit on the ignition key and motor ECU. Used in 1999 – 2003 Lexus cars.
Transponder information is stored in motor ECU. Remove motor ECU from the car, open it and find 93C56 EEPROM marked IC900. Use A6 or A4 adapter and follow CarProg instruction to program transponder key. Short quartz resonator for in-circuit EEPROM programming or remove 93C56 from ECU board.
New Lexus cars with Texas Crypto transponder (4D by Silca). Transponder key is stored in separated immobiliser unit marked “ECU IMMOBILIZER”. Remove immobiliser ECU from the car, open it and find 93LC66 SMD EEPROM.
Use only original factory key. With Silca 4D transponder car will not start.
Use A6 or A4 adapter and follow CarProg instruction to program transponder key.
Short quartz resonator for in-circuit EEPROM programming or remove 93C66 from immobilizer board.
This instruction show you guide on how to solve Bobcat machine trouble code P18A5 suction…
The measured intake manifold pressure (signal from boost pressure sensor) is below the warning limit…
JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…
Here is the instruction show you guide on how to replace fuel tank breather filter…
FENDT 900 Vario COM III tractor Component B092 - Sensor, charge air pressure/temperature reports the boost…
Deutz EMR3 Engine Trouble Code 87 / 97 / FlFCD WATER IN FUEL Solution Error description…