Bendix EC-60 EC-80 Yaw Rate and Lateral Accel. Calibration

Bendix EC-60 EC-80 Yaw Rate and Lateral Accel. Test and Calibration

 

The Yaw Rate and Lateral Accel. Test and Calibration is available on:
✓ Bendix EC-60 Advanced braking systems
✓ Bendix EC-80 ESP/ESP+ braking systems

This test checks the calibration of the Yaw Rate/ Lateral Acceleration sensor when the vehicle is stationary. It also provides the ability to recalibrate the sensor if its values are found to be out of bounds.

 

Related Contents:

2024 JPRO Noregon Commercial Fleet Diagnostics Free Download

Noregon JPRO DLA+ 2.0 Adapter

 

Procedures:

1 Select the Yaw Rate and Lateral Accel. Test and Calibration and press Enter or the Start button.

2 The test dialog will be displayed.

3 From the Sensor Readings tab observe the monitored data values and compare them to the defined acceptable ranges. Select the Graph tab to view a graph of the monitored data values.
4 Select the Calibration tab to perform recalibration of the Yaw Rate/Lateral Acceleration sensor. Important test information is displayed for review. Select the Next button to continue.

5 Click the Start button to begin the recalibration.

6 When recalibration begins the test information will be replaced with a fault display for related braking system faults. When calibration is completed a success message will be displayed. Click OK to dismiss this message.

7 If desired the recalibration can be performed again by clicking the Rerun button to return to calibration instructions.
8 When done, press the Exit button to return to the test selection dialog.

More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide