Sometimes things go wrong and maybe the update is not completed. When this happen you can use the “User Defined” mode for make a manual selection of what upgrade or install.
This is also useful for some Bose audio users that want to update all functions in MMI except Bose modules (Bose updating sometimes will trigger “component protection” and you will need to recode the unit).
Note:For more about Audi MMI Repair articles,please check:Audi MMI Repair
For enable this mode:
Open Green Menu:
MMI 2G SETUP + CAR
MMI 3G SETUP + CAR
MMI 3GP CAR + MENU
RMC CAR + MENU
MIB Not available
Go to swdl and tick “user defined mode”
Don’t reboot, just exit with any button (I usually use RADIO)
Proceed with firmware-upgrade as normal.
When the update starts, you can select “User Defined” instead of “Standard”
And now you can select every module manually.
After ECU reparogramming,it is necessary to write new engine number and machine ID into ECU.So…
PCC1302 PowerCommand Low Coolant Level (Warning or Shutdown) Solution Related Contents: 2024 InPower V14.5…
The function identifies the exhaust temperature and indicates malfunction in the exhaust system. The evaluation…
MTU DiaSys diagnostic software is professional on MTU engine diagnostics and programming.But seems that is…
This instruction show you guide on how to use JPRO Diagnostic to do aftertreatment injector…
There are several different diagnostic vendor adapter support Hyster and Yale forklift truck,here show you…