Scania Truck ALM 000800 Interrupted LIN communication with the siren.
Error identification
LIN communication between ALM control unit E7 and siren N9 does not work.
Related Contents:
2025.05 Scania SDP3 V2.65.2 V2.40 Diagnostic Software Free Download
Scania VCI3 Diagnostic Adapter Full Chips
2025 2018 Scania Multi EPC Parts Catalogue Free Download
Cause
Fault in the LIN bus.
Fault in cable harness or harness-to-component connectors for siren N9.
Internal fault in ALM control unit E7.
Notes
Symptom
The siren does not work correctly.
Action
Check whether a fault code concerning a fault on the LIN bus has been generated.
Check siren N9, including its cable harness and harness-to-component connectors.
Check ALM control unit E7.
For more information about Scania truck,please refer to:Scania Trouble Repair.
Here is the instruction show you guide on how to solve engine speed sensor circuit…
This instruction show you guide on how to use CAT ET 2025A to perform override…
This instruction show you guide on how to install the reverser drive for CLAAS Lexion…
Here is the instruction show you guide on how solve Scania truck RTI 257 road…
This instruction show you guide on how to inspect and clean cylinder block for John…
Here is the instruction show you guide on how to remove and replace cab heater…