This instruction show you guide on how to use Launch X431 IMMO Pro to clone Mercedes Benz VGS-NAG3 gearbox control unit. More information for Benz trouble repair,please refer to Mercedes Benz Trouble Repair.
Device Requires:
LAUNCH X431 IMMO Pro (Amazon Official Shop)
Procedures:
Run Launch X431 IMMO Pro,then select “Gearbox”à”Benz”
Select “VGS-NAG3”à”View Wiring Diagram”
Select “Connected To Mcu_v3 Adapter Plate”
Follow the diagram to build connection
Click “Connect”
Then select “Backup Complete Data”
Input name and save it.
Click Disconnect on Launch X431 IMMO Pro
After the original computer data read successfully,then connect new control unit to restore the backup file
Select “Restore Complete Data”
Select the file you save just now to restore and wait processing
Data restored successfully!
Click “Disconnect,then select “Verification Function”
You will find VIN code same
More test report about Launch X431 please check:Launch X431 Test Report
This instruction show you guide on how to solve Scania truck motion and inclination detector,…
This instruction show you guide on how to solve JCB excavator 140 C130C-13 spool brake solenoid…
Scania truck fault in the CAN communication with the chassis management system (CMS),this instruction show…
The water pumps used on all Phaser/1000 Series engines have been changed. The changes to…
Here is the simple instruction on how to solve Deutz engine EMR3 trouble code 48…
CAT ET 2025A Power Shift Pressure Test function checks whether that the proportional reducing valve is…