XTOOL X100 PAD3+KC501 Adapter Read & Write ECU ST95040

This instruction show you steps on how to use XTOOL X100 PAD3 and KC501 adapter to read and write ECU data for ST95040 chip.

 

Device Required:

XTOOL X100 PAD3 with KC501

 

Procedures:

Connect IC clip cable,KC501 adapter to X100 PAD3 tablet

Then clip ST95040 chip by IC clip cable

Select “Special Function” on X100 PAD3

Select “EEPROM”–>”EEPROM Adapter”

 

Select “Read/Write EEPRM”–>”KC501”

 

Select “ST”–>”ST95040”–>”512×8”

 

Select “Read data”

After reading processing finish,just press “OK” to save EEPROM reading from ECU chip

 

For writing data back to ST95040,back to select “Write data”,then select file which you want to write

 

Done!