After replace a new air production module for Volvo FMX 440,it will show you with U300054 trouble code.
U300054 code:End-of-line (vehicle related) parameter setting (dataset) is missing
Missing Calibration
Parking brake function related plausibility
It is caused by a unknown control module you installed,new control unit must be programmed/calibrated,then it can be identified by your truck.So here i will show you guide on how to use Volvo PTT diagnostic software to do air production module programming for Volvo FMX 440.
Preparations:
2024 Volvo TechTool PTT 2.8.241 APCI 0.7.1.0/2.7.116 All Version Free Download
Volvo Diagnostic Kit (88890300)
Volvo VOCOM 88890300 Diagnostic Kit
Procedures:
Use Volvo VOCOM interface to connect to Volvo FMX 440 truck diagnostic port,and then run Volvo PTT software.
Then we enter the vehicle data we are working on.
It show with a data mismatch:
The product data and central systems data do not match.Due to the mismatch some operations may not be available.Details about the mismatch can be found in Product Status.
There show you the Air Production Modulator APM without a chassis ID.
Select “Program”–>”Replace hardware”
Select “Air Production Modulator (APM)”,then click “Continue”
Automatically checked conditions
Here show you with programming steps and instruction,then click “Continue”
It will program air production modulator automatically
Just wait process…,when it done,click “Exit”
Check DTCs after programming
Here is the how to use guide on Caterpillar machine misfire detection test by CAT…
On the Trucktool diagnostic software Settings view, you can edit single parameters, import and export…
Here is the instruction show you guide on how to solve Scania truck road transport…
Here is the instruction show you guide on how to solve engine speed sensor circuit…
This instruction show you guide on how to use CAT ET 2025A to perform override…
This instruction show you guide on how to install the reverser drive for CLAAS Lexion…