This instruction show you guide on how to reset Service Indicator ESI for Seat Leon 1.4 TSI via VCDS. If you want to know more about VCDS function, please refer to VCD cases.
Preparation:
How to Configure VCDS & Diagnostic Cable for Your Laptop
VCDS 17.8.1 Full+Loader V2/V4 Free Download
Steps:
Connect VCDS interface to Seat Leon obd port, then run VCDS soft.
Select “17-Instruments”
Select “Adaptation-10”
Hit “Channel” and search for “IDE00342-ESI: Resetting ESI”
Hit “New value” and choose “Reset”
Hit “Do It!” then it will show Old value reset new value reset, Replace? Hit “Yes”
It shows Controller accepted the request. Will now read the channel again…. Hit “OK”
Then Go Back，Close Controller, Go Back-06
Now Service Indicator reset already.
If you want to know more about Seat Neon, please refer to Seat trouble repair.
This instruction show you guide on how to solve Scania truck motion and inclination detector,…
This instruction show you guide on how to solve JCB excavator 140 C130C-13 spool brake solenoid…
Scania truck fault in the CAN communication with the chassis management system (CMS),this instruction show…
The water pumps used on all Phaser/1000 Series engines have been changed. The changes to…
Here is the simple instruction on how to solve Deutz engine EMR3 trouble code 48…
CAT ET 2025A Power Shift Pressure Test function checks whether that the proportional reducing valve is…