This instruction will show you guide on how to read fault code of Central Electronics system via Delphi Ds150 on Seat Leon 1.4 TSI 2009.
Steps:
Connect Delphi Ds150 to vehicle, open software. Select vehicle model.
“Seat”–>”Leon II[06-]–>”2009”
Select “Multifunction” –>”Central electronics” system, then click “OBD” icon on the right downside.
Read following information, then click “OK”
Click “Read fault codes”
Get two fault codes:
03266 -Horn
-Short circuit to ground or open circuit
-Permanent
00446 -Function limitation due to under-voltage
-Below lower regulation limit threshold
-Intermittent
More case about Seat Leon, please refer to Seat Trouble Repair.
This instruction show you guide on how to solve Doosan Stage V excavator U013C trouble…
This instruction show you guide on how to solve spool brake solenoid open circuit for…
This instruction show you guide on how to remove and install crankshaft rear seal for…
This instruction show you guide on how to use JPRO diagnostic to do SCR performance…
Here is the instruction show you guide on how to remove and disassemble master cylinder…
This instruction show you guide on how to solve Deutz EMR engine 71 / 2791 /…