2023 JPRO Diagnostics kit with ATC eable/disable function,here show you guide on how to use JPRO Diagnostics to enable or disable ATC (Automatic Traction Control) for Wabco HPB brake.
Related Contents:
2024 JPRO Noregon Commercial Fleet Diagnostics Free Download
The Enable/Disable ATC test is available on:
✓ Wabco HPB brakes and all pneumatic braking systems where the J1587 communication protocol is available
The Enable/Disable ATC test provides the ability to temporarily disable and/or re-enable the ATC on the brake system. Once disabled, the ATC will remain disabled until the user re-enables it or the engine is key-cycled.
The ATC must be disabled prior to performing dyno testing.
1 Select the Enable/Disable ATC (Automatic Traction Control) and press Enter or the Start button.
2 The test dialog will be displayed.
3 The Disable button will disable the ATC and the Enable button will re-enable ATC. The center lamp will display the current state of the vehicle. JPRO DLA+ 2.0
4 The ATC lamp indicator reflects the current state of the ATC dash lamp on the vehicle. It is expected that the ATC lamp indicator will be on when the ATC is disabled and off when the ATC is enabled.
5 Select Exit to return to the Test Selection window.
More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide
This instruction show you guide on how to solve spool brake solenoid open circuit for…
This instruction show you guide on how to remove and install crankshaft rear seal for…
This instruction show you guide on how to use JPRO diagnostic to do SCR performance…
Here is the instruction show you guide on how to remove and disassemble master cylinder…
This instruction show you guide on how to solve Deutz EMR engine 71 / 2791 /…
Here is the instruction show you guide on how to repair P0731 incorrect 2nd gear ration…