This illustration show you guide on how to remove GSM for HITACHI ZX-7 excavator.
Related Contents:
Hitachi MPDr v2.56 v2.25 Diagnostic Software Free Download
Hitachi Excavator ZX-7 Service Repair Workshop Manual 2021
Hitachi Dr.ZX Excavator Diagnostic Tool Cable
Procedures:
1.Set the machine position for inspection and maintenance.
2.IMPORTANT
Set the key switch to the OFF position. Wait 5 minute or longer, and then set battery disconnect switch to the
OFF position.
Set the battery disconnect switch to the OFF position.
3.Open door (1).
4.Fold seat (2). Slide seat (2) to the front end.
5.Remove caps (3) (4 used).
6.Remove cover (4).
7.Remove screw (5), screws, washer (6), bolts (15), and washers (16). Remove the cover (14) assembly.
: 13 mm
8.Remove screws, washers (8) (2 used) and bolts, washer (10).
: 13 mm
9.Disconnect connector (17) and connectors (18) (2 used). Remove cover (9).
10.Remove screws, washers (7) (2 used), bolts (12) (2 used), and washers (13) (2 used). Remove the cover (11) assembly. At this time, duct (19) is also removed at the same time.
: 13 mm
11.Remove bolts, washers (21) (2 used). Remove Bracket (20).
: 13 mm
12.Disconnect connectors (25) (2 used).
13.Remove screws, washers (23) (4 used). Remove GSM (24) from bracket (22).
More repair cases for Hitachi excavator,please refer to:Hitachi Excavator Trouble Repair.
This instruction show you guide on how to solve Deutz EMR3 Engine speed overrun 80…
This instruction show you guide on how to solve Doosan Stage V machine U0632 timeout…
This instruction show you guide on how travel and adjust park brake piston for CASE…
Here is the instruction show you guide on how to replace purge valve for Fendit…
Here is the instruction show you guide on how to JCB machine SPN 102,FMI 1…
This instruction show you guide on how to install preconcave for CLAAS Lexion 480 combine…