Categories: Auto Repair

Chevrolet Cruze ECU trouble result in trunk,light wiper fault

Chevrolet Cruze ECU problems is common.We find this issue exist in many Chevrolet Cruze They will cause:

  • Original remote smart key can not open the trunk.
  • The car’s width lightwill not work
  • Stoplightswork properly,but high-mount stop lamp can’t work.
  • Wiper can not spray the fault phenomenon.

Many car repair shop maintenance staff need to check a lot of places, and finally found the issue of ECU.After check on ECU again and again,we find two IC driver modules don’t have output signal while CPU work properly to output signal to two IC driver modules which type BTS5586.

 

We use multimeter to measure the power of those IC driver module is ok,so we judge the most likely is that the IC control chip is broken.In order to verify our judgment, replace them with two new ones.Then we find that all above symptoms disappear.

Trouble analysis:

ECU internal and external actuator driver IC modules damage result in can’t drive external components to execute the command.

auto

Recent Posts

Valtra BH Series 140-210 Trouble Internal Roll inertial Sensor Fault

This instruction show you guide on how to solve Valtra BH Series 140-210 trouble code SA…

2 days ago

Caterpillar C9 Engine Throttle Position Out of Calibration 28 91-13 Trouble Solution

This instruction show you guide on how how to solve trouble code 28 PID 91-13…

5 days ago

Magneti Marelli 1 AVB-VW ECU Pinout

Vehicles: With AP 1.6, 1.8 and 2.0 Ml engines DE 97 to 99. And for…

1 week ago

Valtra BH Series 140-210 Internal lateral Inertial Sensor Recalibration

This instruction show you guide on how to solve Valtra BH Series 140-210 trouble code SA…

1 week ago

Bendix AutoVue 3G LDW System Driver Assistance Systems (DAS) Tests

JPRO 2025V3 Driver Assistance Systems (DAS) Tests allows the editing of configuration parameters.   Related Contents:…

2 weeks ago

How to Solve PCC2300 PowerCommand Membrane Buttons Not Functioning

This instruction show you guide on how to solve PCC2300 Powercommand Membrane buttons not working.…

2 weeks ago