Categories: How To

Mercedes Benz W204 Windshield Wiper Blades Replacement

Windshied wiper blades replacement is a easy project for vehicle owner to perform.You just need to buy the windshied wiper blades,and follow the instruction.Here I want to share how to replace windshield wiper blades for Benz W204

 

It will take you about 15 minutes.

Applicable Models: Mercedes-Benz W204 (2008-14)

Hot Tip: Clean windshield before installing new blades

Windshield Wiper Blades For Mercedes-Benz W204

 

Related Post: How to replace windshield wiper blades

 

Procedures:

Both wiper blades on the Mercedes C-class are attached to the wiper arms by a single post(red arrows).No tools are needed to change them.The procedures for both blades are the same.

Begin by lifting the arm up while the wipers are in the off position.If you have worries at all about doing this job you should place a large thick towel on the windshield.If you let the wiper arm drop back onto the windshield while there is no blade on it you can crack the windshield and turn an inexpensive DIY job into an expensive one quickly.

Rotate the wiper blade 90 degrees from the arm.You can now just slide the blade off by moving it away from the arm(red arrow)

There is a bracket at the end of the wiper arm(red arrow) that will hold the blade in place when installed.

This photo illustrates how once the blade is installed and turned to the correct position the bracket (red arrow) holds it in place.

auto

Recent Posts

JCB JS140 Excavator C130C-13 Spool Brake Solenoid Open Circuit Solution

This instruction show you guide on how to solve spool brake solenoid open circuit for…

2 days ago

Perkins 400A 400D Industrial Engine Crankshaft Rear Seal Remove and Install

This instruction show you guide on how to remove and install crankshaft rear seal for…

5 days ago

JPRO Diagnostic Software SCR Performance and System Test on Cummings

This instruction show you guide on how to use JPRO diagnostic to do SCR performance…

1 week ago

Yale ERP15-20VT G807 Forklift Truck Master Cylinder Removal and Disassemble Guide

Here is the instruction show you guide on how to remove and disassemble master cylinder…

2 weeks ago

How to Solve Deutz EMR3 71 / 2791 / EGRCD_SigNpl Error?

This instruction show you guide on how to solve Deutz EMR engine 71 / 2791 /…

2 weeks ago

How to Solve Allison 3000 & 4000 Gen5 P0731 Incorrect 2nd Gear Ratio?

Here is the instruction show you guide on how to repair P0731 incorrect 2nd gear ration…

2 weeks ago