Detroit GHG17 Diesel Exhaust Fluid (DEF) Quantity Test will check that the correct amount of DEF fluid is delivered in a certain period of time. A fault code will normally accompany this procedure.
Related Contents:
2024.06 Detroit Diesel Diagnostic Link DDDL 8.20 8.09 Free Download
Note : Using Detroit DiagnosticLink 8.19:
A properly operating system will deliver between 108 and 132mL of DEF once the test has completed.
New doser bolts and gasket are required after running this procedure.
Test as follows:
1 Remove the vehicle side fairing to gain better access to the dosing unit.
2 Remove the three bolts securing the DEF dosing unit to the mounting plate and discard bolts. Do not disconnect the DEF lines or electrical connector.
3 Use the graduated cylinder from DEF kit W060589001900 to measure the DEF dispensed during the test.
4 Place the doser on top of the graduated cylinder with the nozzle facing downward into the cylinder.
5 Turn the ignition ON (key ON, engine OFF).
6 Connect to DiagnosticLink®.
7 From “Actions” drop-down menu, select “Aftertreatment”, then “DEF Quantity Test.”
8 Click the “Start” button to begin the “DEF Quantity Test.”
9 The test will run for four minutes; once completed, verify the amount of DEF dispensed.
More repair cases for Detroit Diesel engines,please refer to:Detroit Diesel Engine Repair
This instruction show you guide on how to solve spool brake solenoid open circuit for…
This instruction show you guide on how to remove and install crankshaft rear seal for…
This instruction show you guide on how to use JPRO diagnostic to do SCR performance…
Here is the instruction show you guide on how to remove and disassemble master cylinder…
This instruction show you guide on how to solve Deutz EMR engine 71 / 2791 /…
Here is the instruction show you guide on how to repair P0731 incorrect 2nd gear ration…