How to Use Cummins Insite Change Road Speed Parameter for Saf-T-Liner C2

In this instruction i will show you guide on how to use Cummins Insite diagnostic to change road speed parameters for Saf-T-Liner C2 bus.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-1

Preparations:

Newest Cummins Insite 8.6 8.4 Free Download

How to Setup Cummins Insite 8.2.0 work with Nexiq usb link

 

Cummins Insite Change Road Speed Parameter Procedures:

Step 1: Connect the laptop to the bus by using the 9-pin diagnostic receptacle inside every C2 located above the driver’s left foot position.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-2

 

Step 2:Click on your desktops Cummins INSITE Icon.

Step 3: Turn key in bus to on position. Bus does NOT need to be running.

Step 4: Click on “Connect to ECM” menu on left and then click “Connect” in pop up window.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-3

 

Step 5: Click on “Features and Parameters”.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-4

 

Step 6: Scroll down menu to Road Speed Governor and click on icon beside to expand its options. The menu is in alphabetical order for ease of use.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-5

 

Step 7: Double click on MPH number on MAX VEHICLE SPEED.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-6

 

Step 8: Enter the new MPH speed required and then click on the number. Note: North Carolina has specific laws for buses in operation. Please adhere to these laws for any bus in-service.

Step 9: Double click on MPH number on MAX ACCELERATOR SPEED and change to same value as MAXIMUM VEHICLE SPEED.

NOTE: New speed is displayed and old speed is displayed to the right.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-7

 

Step 10: On tool bar at top of screen, click on the small computer icon to send info to engine’s ECM.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-8

 

Step 11: Pop up window will indicate you are to turn ignition key off for 30 seconds. Do this and then click OK.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-9

 

Step 12: NEW pop up window will tell you when to turn ignition key back on. When instructed, turn key on and click OK.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-10

 

Step 13: Pop up window will indicate when all parameters were successfully written. Click OK.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-11

 

Step 14: Click Icon on left to disconnect from ECM. When this is complete it is safe to remove laptop connections with bus.

Cummins-Insite-Change-Road-Speed-Parameter-for-Saf-T-Liner-C2-12

(Visited 5 times, 1 visits today)